Category: 3D Print
-
Raspberry & Octoprint
To print stuff on your 3D printer you either handle those nasty sd-cards or you have a pc attached to your printer running all the time. To “FIX” this i decided to set up a raspberry pi with octoprint and have this always attached to the printer. I baught the Raspberry Pi 3 and followed […]
-
Strain relief for the heatbed cables Pursa i3 / Thingiverse
I red a lot about the cables that power the heat/build plate to loosen or suffering from material fatigue and I didn’t find a thing that was fitting my printer setup so I designed one myself and decided to share it on thingiverse. https://www.thingiverse.com/thing:2941788
-
Warping – Bed leveling and the settings
Try Try Try and Try again until you get it right … well thats what i did and still trying to do it better … Leveling the bed was not so much of a problem for the first print, because it was a very tiny one in the middle of the bed and it seemed […]
-
CURA and the first print
Cura is the slicer software of my choice. Why? Well i didn’t knew much when i started using it … and it was recommended by the handbook of the 3D printer. So I set up Cura it was really simple just choosing the printer I had and installing the correct drivers for the printer and […]
-
3D Printer – Pursa i3
3D Printer are in our lives for such a long time now but i actually didn’t get in touch with one myself so … I bought the Anycubic Pursa i3 when it was on sale 🙂 I actually already printed some items – they do look amazing! I’ll share some of my experiences with leveling […]